Do I need to change the heating curve?
If your home stays close to the temperature you select in the app, leave the heating curve as it is. The curve sets the water temperature your heating system supplies at different outdoor temperatures. Tune adjusts the heat around that starting point.
Use the winter history to decide whether to adjust the curve
In the Tune app, look at the average Control Point Adjustment from November to March. A single red or green bar is too little to go on.
- Above +4 on average (green bars). Tune has often asked for less heat. Consider lowering the curve slightly.
- Below −4 on average (red bars). Tune has often asked for more heat. Consider raising the curve slightly.
A positive adjustment makes the outdoor temperature sent to the heating system higher than the measured temperature. The system supplies cooler water. A negative adjustment does the reverse. In warm weather the heating system may already have stopped heating.
If your air-to-water heat pump keeps the house too warm in cold weather
In cold weather Tune limits the outdoor temperature it sends to an air-to-water heat pump to protect defrosting. If your home stays too warm even when Tune reaches that limit, use your pump’s manual to lower the normal heating curve by one small step. Check the indoor temperature before adjusting it again.
Thermostats and settings on the heating system
Start with the room thermostats open where you want Tune to control the temperature. Turn them down in rooms you want cooler. If they were previously turned down throughout the house, opening them may mean the heating curve needs lowering a little. This matters especially for heat pumps.
- Prefer a regular linear curve. If your home is equally too warm or too cold at different outdoor temperatures, check whether your controller can shift the whole curve up or down.
- Keep the minimum and maximum supply temperatures appropriate for your heating system. Underfloor heating needs a lower maximum than radiators. A high minimum can limit savings when you schedule a lower temperature while away.
Troubleshoot a difference between your target and measured indoor temperatures.