My Track is not showing meter readings. What should I check?

Start at the meter. Does your Track have a reader on the front of the meter or a cable plugged into a port?

Track Opto with an optical reader

  1. Check which reading point your meter uses. On some electricity meters Track reads a flashing light marked imp/kWh. On others it reads from an optical port. How to tell them apart.
  2. Check that the reader is still centred over that point. If the batteries need replacing, use two AAA batteries.

Track HAN with a cable

Check that the cable is firmly connected to the meter’s HAN/P1 port and that your electricity network operator has enabled the port. Track HAN gets power through the cable.

If readings are still missing

Email support@ngenic.se with a photo showing the meter model and the position of the reader or cable. Tell us when you last saw a reading. If new Track Opto batteries run down quickly, also tell us when you changed them and how long they lasted.

If you need to add a previously installed Track again, see How do I install Ngenic Track? for the reset button on your model.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us